Trunk lid (coupe and sedan models) — removal, installation and adjustment
Note: The trunk lid is heavy and somewhat awkward to remove and install — at least two people should perform this procedure.
Removal and installation
1. Open the trunk lid and cover the edges of the trunk compartment with pads or cloths to protect the painted surfaces when the lid is removed.
2. Disconnect any cables or wire harness connectors attached to the trunk lid that would interfere with removal.
3. Remove the hinge trim cover (if equipped) and make alignment marks around the hinge (see illustration).
i.3 Draw around the hinge and the bolts with a marking pen before loosening the bolts to ensure proper alignment of the trunk lid when it’s reinstalled
4. While an assistant supports the trunk lid, remove the lid-to-hinge bolts on both sides and lift it off.
5. Installation is the reverse of removal.
Note: When reinstalling the trunk lid, align the lid-to-hinge bolts with the marks made during removal.
Adjustment
6. Fore-and-aft and side-to-side adjustment of the trunk lid is accomplished by moving the lid in relation to the hinge after loosening the bolts or nuts.
7. Scribe a line around the hinge plate as described earlier in this section so you can determine the amount of movement.
8. Loosen the bolts and move the trunk lid into correct alignment. Move it only a little at a time. Tighten the hinge bolts or nuts and carefully lower the trunk lid to check the alignment.
9. If necessary, after installation, the entire trunk lid striker assembly can be adjusted up and down as well as from side to side (see illustration) so the lid closes securely and is flush with the rear quarter panels. To do this, scribe a line around the trunk lid striker assembly to provide a reference point, then loosen the bolts and reposition the striker as necessary. Following adjustment, retighten the mounting bolts.
i.9 Loosen these two bolts to reposition the striker. Be sure to mark the location of the striker for a reference as to how far you have moved it
10. The trunk lid latch assembly, as well as the hinges, should be periodically lubricated with white lithium-base grease to prevent sticking and wear.
11. Finally, adjust the height of the trunk lid in relation to the body by screwing the rubber bumpers in-or-out.