Steering column covers — removal and installation

Warning: Models covered by this manual are equipped with a Supplemental Restraint System (SRS), more commonly known as airbags. Always disable the airbag system before working in the vicinity of any airbag system component to avoid the possibility of accidental deployment of the airbag, which could cause personal injury (see Chassis electrical system).

1. Disconnect the cable from the negative battery terminal (see Engine electrical systems).

2. Remove the driver’s side instrument panel lower cover (see Dashboard trim panels — removal and installation).

3. On tilt steering columns, move the column to the lowest position.

4. Remove the retaining screws, then separate the halves and remove the covers (see illustration).

i.4 Steering column cover retaining screws (sedan model shown, other models similar)

5. Installation is the reverse of the removal procedure.

L
_DV_ send mail

R