Coolant reservoir — removal and installation

Warning: Wait until the engine is completely cool before beginning this procedure.

1. Disconnect the reservoir hose fromthe radiator filler neck. Plug the hose to prevent leakage.

2. On some models it is necessary toremove the air filter housing (see Fuel and exhaust systems) and the battery and battery tray (see Engine electrical systems) for access to the reservoir.

3. Remove the mounting fastener (see illustration).

i.3 Disconnect the reservoir hose fromthe radiator filler neck (1), then remove thecoolant reservoir mounting fastener (2) — 1.8L engine shown, other engines similar

4. Lift the reservoir out of the engine compartment.

5. Clean out the tank with soapy water anda brush to remove any deposits inside. Inspect the reservoir carefully for cracks. If you find a crack, replace the reservoir.

6. Installation is the reverse of removal.

L
_DV_ send mail

R