Output shaft (countershaft) speed sensor — replacement

1. Locate the output shaft (countershaft) speed sensor on top of the transaxle, near the transaxle fluid level dipstick (on coupes and sedans) or on the backside of the transaxle (CR-V models).

2. On Civic 1.8L models and 2014 and earlier CR-V models, remove the air filter housing (see Fuel and exhaust systems). On Civic 2.4L models, raise the vehicle and place it securely on jack stands, then remove the splash shield.

3. Disconnect the electrical connector from the output shaft (countershaft) speed sensor (see illustration).

i.3 Output shaft (countershaft) speed sensor location (Civic 1.8L CVT shown)

4. Remove the output shaft sensor mounting bolt and remove the sensor.

5. Remove and discard the sensor 0-ring.

6. Installation is the reverse of removal. Be sure to use a new 0-ring and tighten the sensor mounting bolt securely.

L
_DV_ send mail

R