Fuel system check
Warning: Gasoline is flammable, so take extra precautions when you work on any part of the fuel system. Don’t smoke or allow open flames or bare light bulbs near the work area, and don’t work in a garage where a gas-type
appliance (such as a water heater or clothes dryer) is present. Since fuel is carcinogenic, wear fuel-resistant gloves when there’s a possibility of being exposed to fuel, and, if you spill any fuel on your skin, rinse it off immediately with soap and water. Mop up any spills immediately and do not store fuel-soaked rags where they could ignite. When you perform any kind of work on the fuel system, wear safety glasses and have a Class B type fire extinguisher on hand. The fuel system is under constant pressure, so, before any lines are disconnected, the fuel system pressure must be relieved (see Fuel and exhaust systems).
1. If you smell gasoline while driving or after the vehicle has been sitting in the sun, inspect the fuel system immediately.
2. Remove the fuel filler cap and inspect it for damage and corrosion. The gasket should have an unbroken sealing imprint. If the gasket is damaged or corroded, install a new cap.
3. Inspect the fuel feed line for cracks. Make sure that the connections between the fuel lines and the fuel injection system are secure and dry.
Warning: Your vehicle is fuel injected, so you must relieve the fuel system pressure before servicing fuel system components. The fuel system pressure relief procedure is outlined in Fuel and exhaust systems.
4. Since some components of the fuel system — the fuel tank and the fuel lines, for example — are underneath the vehicle, they can be inspected more easily with the vehicle raised on a hoist. If that’s not possible, raise the vehicle and support it on jack stands.
5. With the vehicle raised and safely supported, inspect the gas tank and filler neck for punctures, cracks and other damage. The connection between the filler neck and the tank is particularly critical. Sometimes a rubber filler neck will leak because of loose clamps or deteriorated rubber. Inspect all fuel tank mounting brackets and straps to be sure that the tank is securely attached to the vehicle.
Warning: Do not, under any circumstances, try to repair a fuel tank (except rubber components); the fuel tanks in these vehicles are made of plastic and must be replaced if damaged.
6. Carefully check all hoses and lines leading away from the fuel tank. Check for loose connections, deteriorated hoses, crimped lines and other damage. Repair or replace damaged sections as necessary (see Fuel and exhaust systems).